hosttoolbox.blogg.se - Palo alto networks vpn setup

This must be a Fully Qualified Domain Name (FQDN) type, with a value like. This is a unique identifier used to identify and establish this IPSec tunnel.Enter the IP address assigned to your Palo Alto appliance that is reachable from the Wandera cloud in the Customer Primary IP Address field.In the Connectivity and Authentication section, define the following then click Next:.Note: Save this IP address for a later step when configuring the Palo Alto side of the tunnel.Under the Wandera IPSec Source IP Addresses section, select Single IP Address and pick any of the available IPs.Tip: The selected region generally should be as geographically close to your destination network equipment as possible.

Select the global Wandera datacenter in which this interconnect should be provisioned using the Egress Region picker.Only tenants that share a common organization unit structure are applicable for selection. Select the RADAR tenants that should be able to access this route using the Tunnel Availability pick list.In the Provisioning section, define the following then click Next:.This information is used for support purposes. Enter your Technical Contact information, including Name and Email.

Define "Palo Alto" as the IPSec Network Vendor.

This name will be used when selecting it as a routing destination within Access Policies.

In the General section, define the following then click Next:.

Select the Custom IPSec Interconnect option.

Navigate to Integrations > Access Gateways.

These steps will enable you to create a secure route destined towards your Palo Alto appliance, enabling this route to be used for any app access policy. Step 1: Create a Custom IPSec Interconnect in the RADAR

A public IPv4 address assigned and routed to your Palo Alto appliance that is to negotiate the IPSec tunnel with Jamf.

Proper licensing as required to support IKEv2 site-to-site VPN tunnels (consult your documentation for details as needed).

Administrative access to the Palo Alto router/firewall.

Experience and familiarity with managing Palo Alto firewalls.

This guide walks you through the necessary configuration to get up and running. You are able to easily establish secure connectivity between the Jamf Private Access edge and your network edge using an encrypted IPSec Site-to-Site VPN using IKEv2.